Thingiverse
Remixed FTX vantage spoiler
by jonnyg30
25
Downloads
16
Likes
0
Makes
Remixed from EinProBlemo's design to fit the FTX vantage.
printed on a 15cm bed at with ABS at 0.2mm layer height, supports are needed. Took just over 2 hours to print and minimal clean up was required. fit the vantage with no further mods necessary.
Not sure it will survive a roll but we'll soon see!
EDIT: Turns out it handles rolls really well. Thought it would smash to pieces the first time it went over but it surprised me and survived several pretty good spins.......that is until I
printed on a 15cm bed at with ABS at 0.2mm layer height, supports are needed. Took just over 2 hours to print and minimal clean up was required. fit the vantage with no further mods necessary.
Not sure it will survive a roll but we'll soon see!
EDIT: Turns out it handles rolls really well. Thought it would smash to pieces the first time it went over but it surprised me and survived several pretty good spins.......that is until I
Sign in to leave a comment
Sign in