TronXY X1 Spool Holder (Print without support)

I have searched all over thingiverse for a good spool holder for my Tronxy X1 and after printing several failed designs (one bends, the other doesn't fit...) I designed my own spool holder.

This design prints faster than others that I have tried because it is partially hollowed out, but it is strong enough to hold a full 1kg spool without bending.

No support needed!

Instructions:
1)Print the spool holder and the end cap.
2)Screw the spool holder to the top of your Tronxy X1 using the