Thingiverse

Hypercube Evolution 40mm Fan E3Dv6 Mount

by bcprint3d

9 Downloads

1 Likes

0 Makes

Download Model

BLTouch BLTouch levelling bltouch mount E3D e3dv6 E3D Hotend E3D v6 hypercube hypercube 3d printer hypercube evolution HyperCube Printer BLTouch BLTouch levelling bltouch mount E3D e3dv6 E3D Hotend E3D v6 hypercube hypercube 3d printer hypercube evolution HyperCube Printer

I have modified the following:

1.) Added mount for 40x40mm fan. I currently am using a 40x40x28mm fan.

2.) Modified the BLTouch Mount to allow the wires to be run up through the center.

3.) Added zip-tie slots for wire management.

4.) Added support boss to attache the wiring harness to.

5.) Modified the endstop mounts to allow the connector to fit through mount.

6.) Moves most of the threaded brass inserts so they are in compression rather than tension. This will prevent the

Source

Thingiverse

Comments