Thingiverse
Power Bank 6 Cell
by Kaptan_GAK
4
Downloads
5
Likes
0
Makes
This uses a common Ebay powerbank PCBA board
(https://www.ebay.com.au/itm/5V-Dual-USB-Power-Bank-Charger-Charging-PCBA-Circuit-Board-DIY-for-Cell-Phones/173108817636?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649)
Depending on how good your printer is (and my design) you may need to clean up a couple of the hols to be able to slip the PCBA into the print.
The six hols are for clear filament so that the power LED's show their status. I hold the board in place by putting a small
(https://www.ebay.com.au/itm/5V-Dual-USB-Power-Bank-Charger-Charging-PCBA-Circuit-Board-DIY-for-Cell-Phones/173108817636?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649)
Depending on how good your printer is (and my design) you may need to clean up a couple of the hols to be able to slip the PCBA into the print.
The six hols are for clear filament so that the power LED's show their status. I hold the board in place by putting a small
Sign in to leave a comment
Sign in