Thingiverse
Anet Direct Feed Carriage Mount for Original E3D Hotend
29
Downloads
20
Likes
0
Makes
Our last design was designed for the E3D clone.
This design is for use with the Original E3D heat sinks
We have seen a few questions asking if the original E3D would fit the design.
There is a small difference in the clamping shoulders lengths & diameters. We have adjusted these measurements on this design to the same shown on the E3D CAD drawings. If you are unsure if yours will fit measure the clamping shoulders on your heat sink if they are the same as the drawing it will fit.
He
This design is for use with the Original E3D heat sinks
We have seen a few questions asking if the original E3D would fit the design.
There is a small difference in the clamping shoulders lengths & diameters. We have adjusted these measurements on this design to the same shown on the E3D CAD drawings. If you are unsure if yours will fit measure the clamping shoulders on your heat sink if they are the same as the drawing it will fit.
He
Sign in to leave a comment
Sign in