Cr-10/Cr-10s/Ender-3 MR16 light holders/caps

Mr16 led light holders. i made these for cr-10s but work on my ender-3 .they snapped on to Cr -10s no problem. on the Ender-3 they were tight and i had to file the clip edges to get them to sit down few drops of superglue hold the lights in and the caps slip on and cover the exposed wires i soldered on. I used 120v led lights (MR16) from home depot for this and some so cord 18ga 2 wire they have no polarity and wired to a light switch i put un a conduit box i will post pictures to follow