Thingiverse
Garmin 4DV sunshield/splashguard
by jonnyg30
149
Downloads
121
Likes
2
Makes
V3 file added - changed orientation to print without supports as per dergutehirte's remix for the 4/4dv+ (Good spot mate, totally missed that!)
V2 file added - increased width by 3mm to give better fit. part is 110x98x70mm (LxWxH)
Final version printed in ABS at 0.2mm layer height, 20% infill +1% all axis increase to account for shrinkage. supports are needed for flat roof overhang but the angled section of roof doesn't need them. print took 6 hours.
prototype printed in PLA at 0.3mm l
V2 file added - increased width by 3mm to give better fit. part is 110x98x70mm (LxWxH)
Final version printed in ABS at 0.2mm layer height, 20% infill +1% all axis increase to account for shrinkage. supports are needed for flat roof overhang but the angled section of roof doesn't need them. print took 6 hours.
prototype printed in PLA at 0.3mm l
Sign in to leave a comment
Sign in