Thingiverse
Vase Mode Modular Drawers
by mSenyor
426
Downloads
244
Likes
0
Makes
These are modular drawers inspired by Dan O'Connell's Modular Drawers 2.0.
They print in vase mode (a drawer prints about 80 minutes, and the shell about 120).
The shells can be interlocked on any side either flush or offset (3/4, 1/2, or 1/4 way apart).
***EDIT***
Some people had issues with the shell printing into two separate parts. This seems to happen when the width of the extruded material is smaller than half the thickness of the model wall. Possible solutions are higher flow rates
They print in vase mode (a drawer prints about 80 minutes, and the shell about 120).
The shells can be interlocked on any side either flush or offset (3/4, 1/2, or 1/4 way apart).
***EDIT***
Some people had issues with the shell printing into two separate parts. This seems to happen when the width of the extruded material is smaller than half the thickness of the model wall. Possible solutions are higher flow rates
Sign in to leave a comment
Sign in