Typhoon

I liked the 40mm fang for E3D V6 but I didn't think it was enough air flow. I increased the air flow by changing the size of the airway and upgrading it to a 60mm Noctua fan which provides twice as much flow as 2 blowers.

I do recommend to print in PETG or ABS. If printed with PLA the outlets WILL warp and sag, since are fairly close to the heater block

I typically keep the fan on 60% air flow and 100% while bridging.

this is made to be used with the Aluminium E3D V6 mount found on eB