Thingiverse
CR-10/S Solder Stand for Bed Plug
by Konjanx
3
Downloads
2
Likes
0
Makes
When upgrading the CR-10/S bed from the standard heating plate to a silicone mat, you have to solder it to the plug that goes into the control unit. This stand is designed for holding the plug while you solder it. While it's not necessary for this job, it helps.
My print ran out of the sample Creality filament, but just in time to still hold the plug.
Following my build of 20% infill at 0.2mm layer height, this should consume about 16.2m/48g of 1.75mm PLA. Standard CR-10/10S settings
My print ran out of the sample Creality filament, but just in time to still hold the plug.
Following my build of 20% infill at 0.2mm layer height, this should consume about 16.2m/48g of 1.75mm PLA. Standard CR-10/10S settings
Sign in to leave a comment
Sign in