Thingiverse
Odroid C2/C1+ Case (60mm cooling fan)
by Hoppa_
9
Downloads
8
Likes
0
Makes
Another Odroid Case I made. Should also fit a C1+
This one is for a 60mm cooling fan that's 11mm thick.
It requires 4 small screws -> 2.5mm diameter, 4-6mm long screws with maximum 5.2mm diameter head.
The other case I made was too large and bulky, and with an open funnel that sucked in air and dust, I wanted to fix that.
I didn't want the fan face down on the heatsink because it would just suck in dust from the top on to the board.
I designed it so that it draws air from one side to t
This one is for a 60mm cooling fan that's 11mm thick.
It requires 4 small screws -> 2.5mm diameter, 4-6mm long screws with maximum 5.2mm diameter head.
The other case I made was too large and bulky, and with an open funnel that sucked in air and dust, I wanted to fix that.
I didn't want the fan face down on the heatsink because it would just suck in dust from the top on to the board.
I designed it so that it draws air from one side to t
Sign in to leave a comment
Sign in