Thingiverse
Double din to Single din with aux switch mount hole
by DustyDingus
40
Downloads
35
Likes
0
Makes
Remixed to fit my 2003 Ford Ranger because I needed a place to mount the switch for my new Off-Road lights.
I am using a rear support on the receiver from my previous universal double din adapter kit, as well as the bezel that came with my receiver.
The clips could be better, but do a good job of holding it in there as is. Whenever I get around to adding more switches and replacing this again I will improve upon that.
The switch mount hole is sized at 20.5 mm diameter to fit the swi
I am using a rear support on the receiver from my previous universal double din adapter kit, as well as the bezel that came with my receiver.
The clips could be better, but do a good job of holding it in there as is. Whenever I get around to adding more switches and replacing this again I will improve upon that.
The switch mount hole is sized at 20.5 mm diameter to fit the swi
Sign in to leave a comment
Sign in