Hinge small as Raw Material

Print and use this small hinge as raw material
each leaf is approx 12mm width. Suitable for small box/enclosures.
This hinge can use 1/8 (3mm) approx dia screws or smaller.
This is 90mm long but you can cut the length to suit your requirements and keep the rest.
or just move the model in you slicer to the edge to partially print.

Steps:
1. Print HingeLeaf1 and HingeLeaf2
2 .Insert scrap 1.75mm dia filament as a pin. pointed cut the pin. (Bit tight but it will go)
3. Cut to proper l