Thingiverse
Improved Slice Mosquito Groovemount Adapters
by wesc
76
Downloads
142
Likes
0
Makes
This is a in improved version of the Slice Engineering Mosquito Hot End Groovemount Adapters. The original version would sometimes delaminate due to the force of the pushed filament. By running the screws the length of the adapter it should prevent it breaking
It uses two M2x16 (or M2x15) screws and two M2 nuts to secure the adapter to the Mosquito.
Use a short length of 4mm OD, 2mm ID PTFE tube thru the adapter and protruding above a few mm to create a fully constrained filament path.
It uses two M2x16 (or M2x15) screws and two M2 nuts to secure the adapter to the Mosquito.
Use a short length of 4mm OD, 2mm ID PTFE tube thru the adapter and protruding above a few mm to create a fully constrained filament path.
Sign in to leave a comment
Sign in