52mm spool holder for bearing (22mm outer diameter)

Timelapse of the print: https://youtu.be/AsHCN_-_eio

The parts will fit, but it's a tight fit.
The bearings I used are M8 (inner), M22 (outer). They also fit, but also a tight fit.

Full printer settings:

Temperature extruder: 210°C
Temperature bed: not heated
Infill: 20%
Material: PLA
Layer height: 0.2mm
Adhesion: none
Support: none
Software: Reptier-Host V2.1.2
Slicer: CuraEngine
Print speed: 50mm/s
Outer perimeter speed: 45mm/s
Infill speed: 80mm/s