Thingiverse
Underbed piezo holder for z-probe
by derhopp
55
Downloads
21
Likes
0
Makes
Description
The is my piezo disc holder to use as a z probe.
I have mounted it on a Anycubic I3 MEGA. And I was able to reuse the leveling screw and the springs. The more you tighten the screws the better it behaves.
During ABL you have to decrease z and y acceleration. At 500mm/s^2 it works flawlessly.
I recommend to heat the nozzle to 130°C in case you have still plastic on the tip.
The small tail can be used to clip 2 pin dupont sockets and to fasten the cables with cable ties.
The is my piezo disc holder to use as a z probe.
I have mounted it on a Anycubic I3 MEGA. And I was able to reuse the leveling screw and the springs. The more you tighten the screws the better it behaves.
During ABL you have to decrease z and y acceleration. At 500mm/s^2 it works flawlessly.
I recommend to heat the nozzle to 130°C in case you have still plastic on the tip.
The small tail can be used to clip 2 pin dupont sockets and to fasten the cables with cable ties.
Sign in to leave a comment
Sign in