Thingiverse
SAMLA/LACK FILAMENT FEEDER SYSTEM for PC4-M6 Fittings
by L00TW1CK
90
Downloads
40
Likes
0
Makes
Hi!
This is my interpretation of how a Filament Feeder should look like.
For LACK:
Make a 50mm hole underneath your Extruder in the Lack Table.
Put 4 Fittings into "Einsatz" and connect it in the Table with "Huelse".
Connect with PTFE Tubes, that are leading to Your SAMLA or whatever.
For SAMLA:
It fits in a 10mm hole. The screw is for the Inside, the washer for the Outside.
Screw a pc4-m6 PushFitting into this thing, and add an PTFE Tube from LACK or whatever.
This is my interpretation of how a Filament Feeder should look like.
For LACK:
Make a 50mm hole underneath your Extruder in the Lack Table.
Put 4 Fittings into "Einsatz" and connect it in the Table with "Huelse".
Connect with PTFE Tubes, that are leading to Your SAMLA or whatever.
For SAMLA:
It fits in a 10mm hole. The screw is for the Inside, the washer for the Outside.
Screw a pc4-m6 PushFitting into this thing, and add an PTFE Tube from LACK or whatever.
Sign in to leave a comment
Sign in