Raspberri Pi case with open top and botton

I made a more open case for my RPI based off 0110-M-P's much used design.

I made more room for your fingers to get the SD card out.

This one screws together with M3 bolts and comes in two heights to allow for a slim fit or a 15 mm heatsink.

I print it with 0.40mm nozzle (0,48 as per simplify 3d auto setting), 0.2mm layer height in ABS, layers, 3 top, 3 bottom, 3 outline. 45mm/s and a low setting for the part cooler.

Don't go too slow in print speed or you will melt the four screw tow