Thingiverse
2G4 Antenna Holder
von profdryoman
1
Downloads
1
Likes
0
Makes
Just two horizontal (one elevated) and a vertical one (the antenna sticks ~1 cm into the fuselage).
You will need to add minimal supports at the antenna cable guide. Be careful when you break it away after print.
Vertical is secured by zip tie. Horizontal with a matching second part.
The very simple mount plate is for an ELRS receiver. I shrink tube the receiver to that mount and then screw it into place.
Screws are M2 self threading.
You will need to add minimal supports at the antenna cable guide. Be careful when you break it away after print.
Vertical is secured by zip tie. Horizontal with a matching second part.
The very simple mount plate is for an ELRS receiver. I shrink tube the receiver to that mount and then screw it into place.
Screws are M2 self threading.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!