Thingiverse
2S Balance Connector Cap
por bartholomule
0
Descargas
0
Likes
1
Makes
A simple cut of the 3s JST-XH connector to fit a 2s.
Printed in Ninjaflex. It's tight. Non-flexible filaments will probably not fit.
Took some measurements of the 2s and 3s connectors, and cut 2.5mm from the middle of 3dnob's 3S cap. Cut with Prusaslicer.
At 100% size, this is tight when printed in flexible. At 101%, it fits nicely, but is still not too difficult to remove from the balance connector.
Printed in Ninjaflex. It's tight. Non-flexible filaments will probably not fit.
Took some measurements of the 2s and 3s connectors, and cut 2.5mm from the middle of 3dnob's 3S cap. Cut with Prusaslicer.
At 100% size, this is tight when printed in flexible. At 101%, it fits nicely, but is still not too difficult to remove from the balance connector.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!