2S Balance Plug Cover

This is a remix of MBRC3DPRINTS 2S balance plug cover. I extended the cover to fit the full length of the connector and added fillets for a round finish, which should be less likely to get hung up as the plug is tucked into goggle straps (my use case).

You may have to scale the print up or down a few percent to get the best fit. I scaled X and Y to 96% and kept Z at 100%.

I printed in Sainsmart TPU at 15% infill.

###Want to support my work for free?
**Check out [Amazon](https://amzn.to/3ZOvYVI) for your hobby supplies**
(as an affiliate, I earn a small commission if you buy from Amazon, but there is no extra cost to you)