2X2X1 MULTIBIN SIMPLE DRAWER

This is my assembly of a multi-board drawer setup using 1x1x1 drawers. This has everything to assemble and attach to your multiboard wall. I like the texture on the face of my dividers, so I placed them upside down on the build plate. To assemble. Simply use the two double-ended pins. Snap them into the middle of the long divider and snap the two short dividers onto each side, then slide the dividers with textured sides facing out into the bin and place the small pins going from the outside of the bin and snap them all into place. The drawer stoppers simply snap in as well to the top of the drawer channels, then place your drawers in a rocking motion, and you are all set. I do have support that enables They snap off with ease except at the bottom of the bin. I normally pull the edges up into the center of the bin and then use all the tabs to pull the rest of the supports out, and I use a knife to pop out the round supports and the multipoint supports.