2x3x5 Cuboid (Full Functional) - Rubik

A 2x3x5 twisty puzzle full functional.
To make, print each part by the number indicated on the filename.

You only need 1 M3 screw of 14-20mm and 1 spring. You can use the screw and spring of an ordinary Rubik's cube.

All the pieces are oriented in the position with which I print them. The hardest piece to print is Edge2.

I use support in all pieces, except:
Corners (all of them), Edge1, Center2 and Cap

I recommend sanding the edges of the parts closest to the base of the printer, to improve the horizontal turn of the puzzle. Finally a bit of lub will make a better turn.