Thingiverse
2x3x5
por kequals
77
Descargas
63
Likes
0
Makes
A 2x3x5 twisty puzzle. The 2x3 and 2x5 faces can turn 180 degrees, while the 3x5 faces can turn 90 degrees. This puzzle can shapeshift considerably!
To make, print each part by the number indicated on the filename:
* 1 Alignment
* 2 Short Center
* 4 Hidden Center
* 1 Core (not recommended)
* 4 Left Corner
* 4 Right Corner
* 4 Left Chiral Edge
* 3 Right Chiral Edge
* 4 Long Edge
* 4 Outer Center
* 4 Center Edge
* 4 Small Hidden Edge
* 3 Large Hidden Edge
There are only 3 large hidden edges and 3 right chiral edges because the alignment piece combines one of each.
It is highly recommended to use a factory-made core rather than a 3D printed one. You can buy one here:
https://thecubicle.us/qiyimfg-core-p-8461.html
You also need 6 M3 screws and 6 springs. Four screws need to be 20mm and two need to be 15mm. You can buy the screws here:
https://thecubicle.us/moyu-weilong-hardware-p-1666.html
If you use these screws, you need to sand two of them down a bit so they do
To make, print each part by the number indicated on the filename:
* 1 Alignment
* 2 Short Center
* 4 Hidden Center
* 1 Core (not recommended)
* 4 Left Corner
* 4 Right Corner
* 4 Left Chiral Edge
* 3 Right Chiral Edge
* 4 Long Edge
* 4 Outer Center
* 4 Center Edge
* 4 Small Hidden Edge
* 3 Large Hidden Edge
There are only 3 large hidden edges and 3 right chiral edges because the alignment piece combines one of each.
It is highly recommended to use a factory-made core rather than a 3D printed one. You can buy one here:
https://thecubicle.us/qiyimfg-core-p-8461.html
You also need 6 M3 screws and 6 springs. Four screws need to be 20mm and two need to be 15mm. You can buy the screws here:
https://thecubicle.us/moyu-weilong-hardware-p-1666.html
If you use these screws, you need to sand two of them down a bit so they do
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
