Thingiverse
3-12V DC PWM Speed Controller Mount
von freddie_frog
0
Downloads
3
Likes
0
Makes
Hi!
Here is my simple mount for a small 3-12V DC PWM Speed Controller.
I have designed this mount to allow good air flow under the board should it get warm and allow various options to fix it to your model or device.
I have primarily made the bracket to have a good surface area to be able to glue it to wood using hot glue or super glue. Because of the air gap and solid base you can also use screws or bolts in any position under the board. just drill a suitable hole in the desired position to achieve this.
It is quick and easy to print with no Supports needed and no raft either if you prefer not using them.
Comments and advice welcome! Happy printing!
Here is my simple mount for a small 3-12V DC PWM Speed Controller.
I have designed this mount to allow good air flow under the board should it get warm and allow various options to fix it to your model or device.
I have primarily made the bracket to have a good surface area to be able to glue it to wood using hot glue or super glue. Because of the air gap and solid base you can also use screws or bolts in any position under the board. just drill a suitable hole in the desired position to achieve this.
It is quick and easy to print with no Supports needed and no raft either if you prefer not using them.
Comments and advice welcome! Happy printing!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
