Thingiverse
3/4x10 Thread Protector - Mac11 - Airsoft
von HardlyLethal
10
Downloads
13
Likes
0
Makes
Just a simple knurled thread protector for the Mac-11's weird 3/4-10 threaded barrel. Only tested on a VMac9. Should work on other Mac-11s assuming the distance from the end of the barrel to base of the barrel is about 39mm.
Uploaded a v2 after shooting off the tip within the first shot. The original covered the end with a hole as big as the bore. The v2 sits even with the end of the barrel (tapered section extends a bit past though). Print this one if you plan to actual shoot with it on.
Uploaded a v2 after shooting off the tip within the first shot. The original covered the end with a hole as big as the bore. The v2 sits even with the end of the barrel (tapered section extends a bit past though). Print this one if you plan to actual shoot with it on.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
