3.5" Domed Post Cap

This is a very simple domed post cap that I was requested to make by my dad. It's 3.5" square with a slightly domed cap. It is actually designed to be filled, sanded and painted so there is some fairly obvious layer lines on the slight curve of the top surface. Variable layer height helps with this but they do not completely disappear. Should fit somewhat snuggly on to a standard 4x4 post (3.5" finished width) and can be permanently attached with construction adhesive if desired. Nothing super special but I figured somebody might find a use for it! I printed in PLA as I knew it was getting finished and would be indoors. I'd suggest printing in PETG, ABS or ASA if you are going to be putting this outside.