Thingiverse
3.5" hard disk drive storage case
door jytou
16
Downloads
13
Likes
0
Makes
This is a hard case for 3.5 inches hard disk drives. Designed to be stored horizontally (I store them upside down).
You will need some felt pads, the ones I used are 3.5mm thick, roughly 1/8". You can change that value in the file, though, it is called “patin”.
You will need some felt pads, the ones I used are 3.5mm thick, roughly 1/8". You can change that value in the file, though, it is called “patin”.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!