Thingiverse
3.5" HDD Vertical Mount
por NeatOman
0
Descargas
1
Likes
0
Makes
Needed to make this for a "Server" a client bought. It was just a normal PC with no HDD mounting inside and i needed to add storage and data redundancy.
Great if you need to add more internal storage on a PC
Printed in ASA, minimum two walls and solid infill modifiers for the bottom screw mounts. You can get away with PETG if it doesn't get too hot inside the case, but double check print settings for best layer adhesion for PETG
I used double sided sticky tape to hold it in place and then used a center punch before drilling holes. I stuck it to the opposite side of the mount location outside the case. You can use self tapping screws if you choose the #6-32 mount, but you will have sharp exposed screw tips.
Blue Loctite is a good idea too for the M3 nut
Great if you need to add more internal storage on a PC
Printed in ASA, minimum two walls and solid infill modifiers for the bottom screw mounts. You can get away with PETG if it doesn't get too hot inside the case, but double check print settings for best layer adhesion for PETG
I used double sided sticky tape to hold it in place and then used a center punch before drilling holes. I stuck it to the opposite side of the mount location outside the case. You can use self tapping screws if you choose the #6-32 mount, but you will have sharp exposed screw tips.
Blue Loctite is a good idea too for the M3 nut
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
