MakerWorld
Other House Models
Ver Modelo
3 inch duct Y adapter
40
Descargas
9
Likes
22
Makes
Needed a Y splitter / adapter for my 3 inch exhaust duct from my two printers. Could not find a model on Maker World or other sites. Commercial models on Amazon we're about $12 and would take a week to arrive. So designed and printed this in Fusion 360. Printed in PETG. Would not recommend PLA. Have not tested in ABS/ASA, Have optimized the print profile and used limited supports. Should be very strong if you use my profile. Have added grooves for clamps. Prints in less than seven hours on a PS/2 should cost less than $10 in filament.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
