MakerWorld
RC
Zum Modell
3 Inch Fpv Frame
20
Downloads
12
Likes
3
Makes
SummaryIf you're printing this out of TPU, you might want to add more infill around the stack and PLA plates under it to stop it from getting too much stress on impact.10mm standoffs in the back and two M3 nuts in the frontFits 9-12mm motor hole patterns20x20mm stack (max. 35x35mm, with some extra space at the back for the battery pads)For 14mm (nano) cameras
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
