3 Pin Lock With Key

---- Sanding required for snug fit. ---- Fine Sandpaper will do. (P400)
The cylinder slides free if the all the pins are aligned correctly, so I would recommend to add some kind of restrainer to prevent the cylinder from sliding out.

I would recommend placing the bed a bit closer (paper thickness + slight friction) to the nozzle so both sides of the lock look nice.

The lock works best/smoothest when both the cylinder and the cylinder holder are exactly aligned. You can do this by pushing them flat on a flat surface.

TODO:
- Add a mover thingy and retainers to ensure that the cylinder stays in place.
- Add some kind of arm that the key moves when its unlocked.

Instructions:
1. Print The Key (Key.stl)
2. Print The Lock Cylinder (Cylinder.stl)
3. Print The Outside Housing (CylinderHolder.stl)
4. Print Three of the Locking Pins (3XLockPin.stl)
5. Print Each one of the pins (PinA.stl, PinB.stl, PinC.stl)
6. Sandpaper the outside of the Lock Cylinder and the inside o