3001 Brick Desk Light

I made a scaled model of a 3001 brick that works as a smart light using translucent PETG for the brick itself. Part of the trick was laying the pieces out in such a way that the infill would create “light channels” for the LEDs to fill through the height of the block, and I think it came out pretty nice in the end! A little button on the side of the box gives you control of it without needing the app/webUI from WLED. Project Notes:the soldering on this one is a bit of a challenge, involving some very small wires!the profile I&#39;m providing is for a 0.6 nozzle since it works best for transparent PETG effects. This would probably work fine with a 0.4 but I strongly suggest using a 0.6 for the brick part at least!the stand would print better with a 0.4 nozzle, even better with a finer layer height (<0.2mm), but I was happy with mine printing at 0.24mm height using the 0.6 nozzleParts used:~0.5m of 5mm width WS2812B 60/m LEDs1x D1 Mini v31x USB-C Snap-in power jack1x Momentary SPST push