Thingiverse
Zonestar P802QR2 Extruder Cable Cover
by BoothyBoothy
32
Downloads
16
Likes
0
Makes
Update:24_08_18
Version 2 includes retention loops for the Boden tubes.
This is a Cable cover for the top of the Extruder for the Zonestar P802QR2.
The cover fastens to the existing 3.5mm hole to the left of the extruder head. You will need a M3 x 7mm minimum bolt and nut. I used a M3 x 10mm but spaced off the front with washers.
Printing
Does not require support, 0.2 resolution with 20% infill.
Version 2 is printed on its side. I have included some break away supports where r
Version 2 includes retention loops for the Boden tubes.
This is a Cable cover for the top of the Extruder for the Zonestar P802QR2.
The cover fastens to the existing 3.5mm hole to the left of the extruder head. You will need a M3 x 7mm minimum bolt and nut. I used a M3 x 10mm but spaced off the front with washers.
Printing
Does not require support, 0.2 resolution with 20% infill.
Version 2 is printed on its side. I have included some break away supports where r
Sign in to leave a comment
Sign in