Thingiverse
RC plane CG balancer
by DrVork
153
Downloads
107
Likes
0
Makes
Simple RC plane GC balancer.
Easy to make with 10mm pipe.
Adjustable width.
Not suited for biplanes.
MAKE SURE YOU PRINT ONE JOINT AS IT IS AND THE OTHER ONE MIRRORED.
It will probably be fine if both are the same, but I like it more when it's symmetrical.
The pipe lengths I used:
2x 20cm for the feet
2x 28cm for the vertical support
1x 32cm for the horizontal bar
I used thin double sided tape and a piece of thin rubber on the aircraft support to make sure the plane does not sl
Easy to make with 10mm pipe.
Adjustable width.
Not suited for biplanes.
MAKE SURE YOU PRINT ONE JOINT AS IT IS AND THE OTHER ONE MIRRORED.
It will probably be fine if both are the same, but I like it more when it's symmetrical.
The pipe lengths I used:
2x 20cm for the feet
2x 28cm for the vertical support
1x 32cm for the horizontal bar
I used thin double sided tape and a piece of thin rubber on the aircraft support to make sure the plane does not sl
Sign in to leave a comment
Sign in