Thingiverse
TRS-80 Model 1 - Screw Standoffs Plate
by barrakuda
10
Downloads
7
Likes
0
Makes
NOTE: Before permanently gluing this to the case, do a test fit with a hot glue gun.
TRS-80 model 1 computers have screw standoffs that can break or get stripped over time. This screw standoffs plate can be used to replace all screw standoffs completely.
The standoffs plate needs to be printed in two separate pieces due to the length. Unit of measure is millimeters (mm).
To install, remove all original screw standoffs with a rotary tool like a Dremel. Then, use a strong epoxy plastic ad
TRS-80 model 1 computers have screw standoffs that can break or get stripped over time. This screw standoffs plate can be used to replace all screw standoffs completely.
The standoffs plate needs to be printed in two separate pieces due to the length. Unit of measure is millimeters (mm).
To install, remove all original screw standoffs with a rotary tool like a Dremel. Then, use a strong epoxy plastic ad
Sign in to leave a comment
Sign in