CPAP BiPAP hose clamp for sleighbed

CPAP hose holder clamp (22mm) Designed to fit my sleighbed headboard ~44mm radius and 30 degree front tangent angle.

If you print this in PLA ~15% infill, it is easily re-shaped in hot water (or a blow dryer - I prefer hot water).

The clamp should print near perfect size for typical hose, but can be adjusted with hot water as mentioned.

The tightening screw is at an angle to be perpendicular to the tangent curve on my bed. If you bed is flat, maybe add a piece of cloth, rubber, etc so t