Thingiverse
Anet a8 nut caps
by mathcanbefun
6
Downloads
9
Likes
0
Makes
Simple nut cap for Anet A8. Designed for the nuts on the threaded rod located on the front acrylic face plates. Beveled top edge
The nuts are about 18mm long with the hexagonal cutout being 15mm deep. It does not interfere with the bed in any way.
Printed with 3d solutech PLA. 15% "fast honeycomb" infill. Oriented with the logo up. Add supports to bolster the top as it is layed down. 0.2 resolution support pillars will be fine. Horizontal offset from parts (in support menu) can be 0.3 possibly
The nuts are about 18mm long with the hexagonal cutout being 15mm deep. It does not interfere with the bed in any way.
Printed with 3d solutech PLA. 15% "fast honeycomb" infill. Oriented with the logo up. Add supports to bolster the top as it is layed down. 0.2 resolution support pillars will be fine. Horizontal offset from parts (in support menu) can be 0.3 possibly
Sign in to leave a comment
Sign in