Karl's Waterer (For the cat) *Source Files Included*

So this is for the cat, he likes the sink! Also, He's Karl.

You'll need some screws, 3mmx50mm x 2 and 3mmx15mm x 16.

Also some RTV sealant or epoxy for the faucet and bottom, these are removable for easy printing since this need support and sanding to be super smooth!

You can see I drilled out the holes and put in stainless steel hi-lo thread screws with a coat of epoxy around the edge. IT MUST BE AROUND THE EDGE AND ON THE FLAT! Or it wont fully seal!

Uses this pump or alike: http