3030 Frame Camera Mount

NOTE: the clearances of the moving parts is a bit tricky at 0.2mm. I may try 0.3mm and update accordingly.

** Update 2018-09-26 **
Added a second longer 90mm frame to get a larger camera to not overhang the build area. Also added a "USB" extension style pillar mount to allow a simple USB light to be plugged in and mounted near the camera (on mine I will use the 50mm mount for the light and the 90mm for the camera). The USB mount will need supports most likely (at least I used them).
****

This is a completely tool-less design. No additional hardware needed and can be printed as is. I used supports to make sure the post had clean edges at the bottom and the small threaded hole is clean, but it may be possible to print without. I printed high quality given the small parts and tight tolerances.

1. The two 3030 mounts will only turn 90 degrees in the 3030 frame and in the mount platform; make a note of the rounded off corners before you twist to free the mounts. They need to rota