Thingiverse
Minifig Stand Hollow and Lightweight
by trif
52
Downloads
29
Likes
0
Makes
Had to print a lot of these so tweaked the original design a number of times,
The "easiest" was "Hollow3" as that takes 11.3 mm staples so is quick to put up
(if you miss and hit the plastic it'll probably shatter but they're less than a gram with 2 walls and a bit of infil so just print a bed full!)
The "easiest" was "Hollow3" as that takes 11.3 mm staples so is quick to put up
(if you miss and hit the plastic it'll probably shatter but they're less than a gram with 2 walls and a bit of infil so just print a bed full!)
Sign in to leave a comment
Sign in