Thingiverse
Feather Holder
by ostopme
7
Downloads
0
Likes
0
Makes
Attach craft feathers to a motor.
The motor this is designed for is a standard 3.3v hobby motor, and the feathers should slot into the holes around the outside of the perimeter pointing inwards.
The fit for the motor into the feather holder might be quite tight depending on your printer settings, so keep a 2mm drill-bit handy to enlarge if necessary.
In the picture, I'm using M4x25mm bolts and an elastic-band to hold the motor in place, if you upgraded to M4x50 or even M4x75 then you co
The motor this is designed for is a standard 3.3v hobby motor, and the feathers should slot into the holes around the outside of the perimeter pointing inwards.
The fit for the motor into the feather holder might be quite tight depending on your printer settings, so keep a 2mm drill-bit handy to enlarge if necessary.
In the picture, I'm using M4x25mm bolts and an elastic-band to hold the motor in place, if you upgraded to M4x50 or even M4x75 then you co
Sign in to leave a comment
Sign in