Croc Spartan Pin

I printed this Croc Pin with PLA Green and then White. I've been using a piece of 3/16 Polycarbonate mounted on glass and ruffed up with 220 sandpaper as my base and haven't looked back at Glue again. Anyone want to buy some semi-used glue sticks?

Nozzle:0.3
Speed: 45mm/Sec
I added some Gcode to Pause the print after layer 48 (0.2mm layer height) and move the nozzle up and out of the way so I could change the PLA filament to white.

; Setup to Pause the Print Job
G91; Set Coordinates to