Thingiverse
cetus pcb cover(remix) for MK2
by imaicom
14
Downloads
3
Likes
0
Makes
I tried a meaningless bulge. The Y axis was rotated 180 degrees to facilitate printing.
The filament bends inside the feed mechanism. Therefore, straightening is not good. I also prepared a large hole version.
How, the filament guide resulted in this alone. All other filament guides were unnecessary to follow up and down the extruder's Z axis.
Probably you should print with ABS filaments. It drips with stepping motor heat. Cetus should not use ABS because PLA is standard.
TEST06:
The filament bends inside the feed mechanism. Therefore, straightening is not good. I also prepared a large hole version.
How, the filament guide resulted in this alone. All other filament guides were unnecessary to follow up and down the extruder's Z axis.
Probably you should print with ABS filaments. It drips with stepping motor heat. Cetus should not use ABS because PLA is standard.
TEST06:
Sign in to leave a comment
Sign in