Ikea Lack Brackets and Riser Using Wood 2x2

My printer is too tall to fit under the Lack table without a riser, but the first set I made was a giant brick that ate up an entire spool even with extremely weak/flimsy print settings. So sure enough, they broke the first time I bumped it.

The second time around, I came up with these. They fit a standard 2x2 onto the end of the leg and then hold the 2x2 in place on the surface of the bottom table. Just cut your 2x2 to the amount you need the top table raised and you're set. No wasting loads