Thingiverse
Jenga Sleeve
by muchtall
52
Downloads
34
Likes
0
Makes
A sleeve meant to enclose the Jenga block holder/aligner device here: https://www.thingiverse.com/thing:826036
Basically a remix of https://www.thingiverse.com/thing:1952372, which had walls that were too thin and therefore not durable enough. This doubles the wall thickness from 0.8 mm to 1.6 mm.
The font used for the Jenga label is just from the basic fonts in Tinkercad. Feel free to modify if know of a better font to put on there...
This thing was made with Tinkercad. Edit it online
Basically a remix of https://www.thingiverse.com/thing:1952372, which had walls that were too thin and therefore not durable enough. This doubles the wall thickness from 0.8 mm to 1.6 mm.
The font used for the Jenga label is just from the basic fonts in Tinkercad. Feel free to modify if know of a better font to put on there...
This thing was made with Tinkercad. Edit it online
Sign in to leave a comment
Sign in