Thingiverse
Tunnel with staircase - Including Fusion 360 design video
by Depronized
57
Downloads
51
Likes
0
Makes
Quick and dirty project to create an enclosed staircase for my daughters guinea pigs.
Edit: as pointed out by one user, depending on material and finish it might not be safe for pets, you use this on your own risk. I will remove this if it turns out they chew of pieces from it.
The height difference is roughly 12cm and the length is about 22cm.
Check out the design video below. I printed this using 0,35mm layer height and 5% infill. Use a brim to make sure it sticks to the bed as there
Edit: as pointed out by one user, depending on material and finish it might not be safe for pets, you use this on your own risk. I will remove this if it turns out they chew of pieces from it.
The height difference is roughly 12cm and the length is about 22cm.
Check out the design video below. I printed this using 0,35mm layer height and 5% infill. Use a brim to make sure it sticks to the bed as there
Sign in to leave a comment
Sign in