RB1, RB3, RBB3 X Limit Switch End Stop - 3096

This print's purpose is to give the X limit switch an end stop.

Our Skip-Sense enabled RB3 and RBB3 printers already have a threaded hole on the X-Z rail, but the RB1 printers with a steel frames will need to have a hole drilled and tapped for an M4 bolt. The hole is in line with the rod connector on the other side. The rod connector can be used as a guide for locating the hole. If you use a 1/8" drill you can use an M4 bolt to self tap the hole.

If printed with calibrated filament the bra