Thingiverse
Olympus FL-LM3 flash diffuser
by snapwithdale
47
Downloads
30
Likes
1
Makes
Little flash diffuser for the flash that comes with the Olympus OMD M5 mkii. It slips on and grips it slightly so is unlikely to fall off (based on how my printer produced it).
One side is vertical and the other is at an angle. So you can experiment with mounting it in both directions to get a slightly different result (I assume).
I printed with ABS. I'm sure PLA would be fine too, as this flash hardly gets hot. I went with white for a white light. If you printed with another color then
One side is vertical and the other is at an angle. So you can experiment with mounting it in both directions to get a slightly different result (I assume).
I printed with ABS. I'm sure PLA would be fine too, as this flash hardly gets hot. I went with white for a white light. If you printed with another color then
Sign in to leave a comment
Sign in