Thingiverse

Creality auto levelling capacitive sensor holder - 18mm low profile

by TRAXA

134 Downloads

67 Likes

1 Makes

Download Model

auto level auto bed leveling bed leveling Creality CR-10 Creality CR-10s creality ender 2 creality ender 3 Ender Ender-3 Ender 3 ender 3 upgrade EZABL Mini-EZABL auto level auto bed leveling bed leveling Creality CR-10 Creality CR-10s creality ender 2 creality ender 3 Ender Ender-3 Ender 3 ender 3 upgrade EZABL Mini-EZABL

Yet another simple sensor bracket for the Creality range of printers..
Fits the 18mm diameter capacitive or inductive sensors, and mounts onto the fan shroud / cover with two m3 x 16mm screws, 4 washers and 2 nylocs.. Takes about 5 minutes to fit..
I've printed this in PET-G at 100% infill, 0.1mm layers and 1.2mm walls but this is way overkill.. PLA with 0.2mm layers and 40% fill, with 1.2mm walls will be more than adequate.

Pic also shows my ZedThing sensor interface board.. Complete set

Source

Thingiverse

Comments